Products

Infrared Ceramic Heating Plate With Thermocouple

Description

Infrared ceramic heater are widely used in pre-heating of plastic sheets for vacuum forming & thermoforming, drying paints, lacquer & varnish curing, drying printing inks, drying textiles, activating adhesives, removing surface water from objects or moisture removal from fabric and paper, animal husbandry and rearing. The ceramic IR heaters are highly efficient. Ceramic infrared heater offers precise targeting and control with minimal peripheral heat. It is possible to apply heat only where and when it is required. The energy in an infrared heater is transmitted at the speed of light from the element to the product. A constant rate of heating is obtained because the source temperature is normally much higher than that of the product even at the end of the heating cycle.

Product Name	Electric ceramic heater
Color	White, yellow, black, etc
Power	125-1500W
Usually size	245 x 60, 245 x 80, 122 x 122, 122 x 60, 60 x 60mm
Shapes	Trough, Hollow and Flat
Voltage	110-440 volts
Thermocouple	Optional, K or J Type
Operating Temperature	300C - 700C

Product Advantages

1. Good chemical stability, strong oxidation resistance and high corrosion resistance;

2. Use non-radiant surface with small heat loss and energy saving;

3. Matrix (not glaze) heated to 800 ℃ in cold repeated dozens of times no crack;

4. The radiating element (finished product) is electrified and heated to the rated power, and the product is immersed in cold water for 40 times without loss after power off;

5. Component radiation rate is greater than 0.9.

Application

1. Widely used in Injection Moulding.

2. Film extruders.

3. Blow Moulding.

4. All Plastic & Rubber Processing Machinery.

5. Laboratory Equipment.

ceramic heating plate (1)